Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-47
Operator Manual © 2008 General Electric Company. All rights reserved.
10. Select the Laterality:
The selected anatomy determines which laterality options are available.
– If the anatomy is unpaired, then Unpaired is the only available selection.
– If the anatomy is paired, the available sections are: Both, Left, and Right.
– Paired anatomy enables the Patient Side control on the Image Acquisition screen. Refer to
Chapter 6:
Image Acquisition for more information.
11. Select the Default Position:
The selected anatomy determines which positions are available. In general:
– If the anatomy is unpaired, the selections are Head Down or Head Up
– If the anatomy is paired, the selections are Digits to Back, Digits to Feet, Digits to Front, Digits to
Head.
12. Press [NEXT].
The Add View (or Edit View) screen (2 of 2) appears.
13. Select all Patient Sizes you want available for the view. The default size will automatically be selected.
14. Select Receptors and Modes for each selected receptor.
15. Select the Default Receptor - cassette or GE Digital Detector.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
