To Next Page

To Previous Page

GE MEDICAL SYSTEMS PROPRIETARY TO GE

IRECTION 2294854-100, REVISION 3 LOGIQ™ 9 PROPRIETARY MANUAL

Chapter 7 Diagnostics/Troubleshooting 7-21

High Voltage Reset Utility

Tests whether all TD boards can detect a high voltage fault.

Set VRF Utility Set the analog VREF to a specified value.

Set TGC Utility Set the analog TGC to a specified value.

Probe Select Utility Select a probe connector to be active.

Probe ID Read Utility Read the Probe ID of all installed probes.

Front-End Calibration Utility

Measures the Front End DC Offset, Gain, and Phase.

Table 7-2 Acquisition Diagnostics and Utility Listing (Continued)

Diagnostic/Utility Function

Other manuals for GE LOGIQ 9

Questions and Answers:

Need help?

Do you have a question about the GE LOGIQ 9 and is the answer not in the manual?

General

Power Requirements	100-240 VAC, 50/60 Hz
Application	General Imaging
Display Type	High-resolution
Transducer Types	Linear, Phased Array, Volume
Operating Modes	B-Mode, M-Mode, Color Doppler, Power Doppler
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler, Tissue Doppler
Connectivity	DICOM, USB, Ethernet, Wireless
Approximate Dimensions	1350 mm (H) x 550 mm (W) x 850 mm (D)
Approximate Weight	85 kg