GE MEDICAL SYSTEMS PROPRIETARY TO GE
D
IRECTION 2294854-100, REVISION 3 LOGIQ™ 9 PROPRIETARY MANUAL
Chapter 8 Replacement Procedures 8-57
8-11-3 Patient, Report, and User-Defined Backup Protocols (cont’d)
3.) Select the Utility tab on the Measurement Selection Menu. Select System, then Backup/
Restore.
4.) Select everything under Backup by placing a check mark in front of Patient Archive, Report
Archive, and User Defined Configuration. Then press Backup.
NOTE: The detailed section of this menu decouples the user defined configuration above. This allows
you to selectively restore what you want to restore across multiple machines. Refer to Chapter
16 for more information.
Figure 8-61 Format Successful Pop-up Menu
Figure 8-62 Backup Menu
To Next Page
Loading...
Need help?
General
