GE MEDICAL SYSTEMS PROPRIETARY TO GE
D
IRECTION 2294854-100, REVISION 3 LOGIQ™ 9 PROPRIETARY MANUAL
Chapter 8 Replacement Procedures 8-85
8-16-5 GE USB Control Panel Driver Loss (cont’d)
11.)In the GENERAL
Tab for the hardware device select REINSTALL DRIVER.
12.)Select NEXT
in the Driver Upgrade Wizard.
13.)Ensure that the Search for a suitable driver for my device (recommended) button is highlighted and
then click on NEXT
.
14.)From the Locate Driver Files window select Specify a location. Then click on NEXT
.
15.)In the Copy manufacturer’s files from: drop down box select C:\WINNT\System32\Drivers and
select OK
16.)The Found Driver window will appear with the selected driver for the hardware device. Select NEXT
to install the driver.
17.)Select FINISH
from the last Driver Upgrade Wizard screen.
There should not be other problems but, if there are other hardware devices that need correcting, repeat
step number 10 through 17.
NOTE: Double check in the Device Manager the under USB Controllers to ensure that the GE USB
Control Panel has no yellow question marks or exclamation marks in a yellow oval.
18.)Close all windows and select the GO MUSASHI
shortcut to start the echoloader application. The
touch panel and GE control panel knobs, buttons and switches should now be fully functional.
Figure 8-94 Good USB Drivers