407
3 Enter a file name and choose the file type.
4 Click Save.
Note: Copy To does not use the clipboard, so anything on the clipboard can still be pasted after
using Copy To.
Using Duplicate to copy and offset an object
The Duplicate command in the Edit menu creates a copy of the current selection and places that
copy at an offset from the originals. The offset value is configured on the Detail tab of the Tools
> Options dialog box.
To use Duplicate
1 Select the object to copy.
2 Click Edit > Duplicate to copy the object and paste it on the work surface at an offset
from the original.
Note: Duplicate does not use the clipboard, so anything on the clipboard can still be pasted
after using the Duplicate command.
Tip: Objects can also be repeated by using Tools > Repeats/Merge and Tools > Advanced
Repeats.
Deleting parts of the design
To delete part of your design without deleting the entire file, use Delete in the Edit menu. If you
delete an object and then change your mind and want to restore it, you must click Undo before
doing anything else.
To delete parts of the design
1 Select the object to delete.
2 Click Edit > Delete.
Tip: The Delete key on the keyboard works the same as the Delete command in Edit.
To Next Page
Loading...
Need help?
General
