ROLL-OVER SENSOR CONNECTOR
1. Control unit (Yellow)
2. Ground (Black)
Remote seat opening
The vehicle is equipped with a remote control to open the saddle.
This remote control is supplied together with the keys and at the manufacturing stage, it has been
programmed to work together with the ECU that control the opening device.
If the remote control is lost, a new one can be requested and programmed, by resetting the ECU memory
and following the same steps as per programming the immobilizer system in the keys.
Battery replacement
The remote control in the black ignition key is pow-
ered by inner batteries that get discharged after
extended used.
You may need to replace the batteries if the re-
mote control fails or if its range of operation is
reduced.
To replace the batteries, separate the two halves
of the remote control by inserting the blade of a
plain slot screwdriver at one point on the edge and
slide it all around.
Electric characteristic
Batteries used:
CR1616
Electrical system GP 800 i.e.
ELE SYS - 62
To Next Page
Loading...
