Gilera GP 800 i.e. - Steering Fifth Wheel Track Fitting

- Remove the lower fifth wheel seat on the steering
tube using the specific tool.
Specific tooling
020004Y Punch for removing fifth wheels from
headstock
STEERING FIFTH WHEEL TRACK FITTING
- Thoroughly clean the track seats on the headstock and the steering tube.
- Fit the new tracks of the headstock with the specific tool.
- Screw the nut until the tracks are fully inserted.
N.B.
LUBRICATE THE STEERING FIFTH WHEEL TRACKS WITH RECOMMENDED GREASE BEFORE
USE.
Specific tooling
001330Y Tool for fitting steering seats
001330Y014 Tool for fitting steering seats
001330Y015 Tool for fitting steering seats
Recommended products
AGIP GREASE PV2 Grease for steering bearings, bolt seatings for swinging arms and faying
surface of driven pulley spring (only pulley side)
Soap-based lithium and zinc oxide grease containing NLGI 2; ISO-L-XBCIB2
Suspensions GP 800 i.e.
SUSP - 20