Gilera GP 800 i.e. - Refitting the Driven Pulley Shaft Bearing; Removing the Driven Pulley Shaft Bearing

Removing the driven pulley shaft bearing
- Remove the transmission cover.
- Remove the seeger ring.
- Place transmission cover on a wood surface and
use the special tool so that it is adequately sup-
ported.
- Pull out the bearing using the special tool.
N.B.
BELL MUST BE PLACED INTO THE TRANS-
MISSION COVER, CLOSE TO THE BEARING
SEAT AND THE WOODEN SURFACE, SINCE
WITHOUT BELL THE ENTIRE COVER STRUC-
TURE WOULD BEND. NOT ONLY IN THE AREA
OF MAXIMUM STURDINESS.
Specific tooling
001467Y002 Driver for OD 73 mm bearing
020376Y Adaptor handle
020357Y 32 x 35 mm adaptor
020363Y 20 mm guide
Refitting the driven pulley shaft bearing
- Heat the transmission cover interior using the heat gun.
Specific tooling
020151Y Air heater
- Place the bearing onto the special tool with a little grease to prevent it from coming out.
- Install the new bearing using the special tool.
Specific tooling
020376Y Adaptor handle
020359Y 42x47-mm adaptor
020363Y 20 mm guide
GP 800 i.e. Engine
ENG - 5