Gilera GP 800 i.e. - Rear Wheel Hub Service

- Move the wheel to the front part of the vehicle so
as to obtain chain clearance to remove it from the
sprocket.
- Release the calliper holding plate from the disc.
- Remove the wheel.
REAR WHEEL HUB SERVICE
- Remove the protection sleeve and the spacer
from both sides using a flat blade screwdriver as a
lever.
- Visually inspect if the components are in good
conditions and that they exhibit no signs of abnor-
mal wear.
- Acting on the specific tool, pull out one bearing.
Specific tooling
020467Y020 Pliers to extract 30 mm bearings
001467Y002 Driver for OD 73 mm bearing
GP 800 i.e. Suspensions
SUSP - 25