Gilera GP 800 i.e. - Engine to Chassis Locking Torques; Nut Fixing Silent-Block Plate

C. Pin fixing nut - M14
D: Pin fixing nut - M10
E: Upper nut fixing engine support link rods - chassis
F: Lower nut fixing engine support link rods - chassis
- Follow the removal steps but in reverse order; be careful to tighten to the prescribed torques.
ENGINE TO CHASSIS LOCKING TORQUES
Name Torque in Nm
Nut fixing silent-block plate - chassis 22 ÷ 25
Nut fixing silent-block plate 33 ÷ 41
Pin fixing nut - M14 124 ÷ 153
Pin fixing nut - M10 47 ÷ 52
Upper nut fixing engine support link rods - chassis 33 ÷ 41
Lower nut fixing engine support link rods - chassis 33 ÷ 41
- Restore all the retainers, check the engine oil level and top-up with the recommended oil type if nec-
essary.
- Fit the complete muffler unit.
- Fit the pinion unit, the rear fork together with the wheel and check if the chain tension is adequate.
- Fill and bleed the cooling circuit.
- Check the functioning of the accelerator and the electrical devices.
Engine from vehicle GP 800 i.e.
ENG VE - 16