Gilera GP 800 i.e. - Hydraulic Rod Fixing Screw

- Fit the hydraulic rod fixing screw with the copper
sealing washer and tighten to the prescribed tor-
que using the recommended product.
CAUTION
ALWAYS USE NEW COPPER WASHER.
Locking torques (N*m)
Hydraulic rod fixing screw 25 ÷ 35*
(°) Apply LOCTITE 243 threadlock
- Lock hydraulic rod rotation using the specific tool.
Specific tooling
020632Y 22-mm Hexagonal spanner
- Fit the upper sliding bushing and the bushing stop
washer inside the fork leg.
- First grease the splitting chamber of the two seal-
ing lips of the new oil seal.
- Fit the sealing ring on the stem and keep the
identification words facing upwards.
Suspensions GP 800 i.e.
SUSP - 14