Gilera GP 800 i.e. - Driving Pulley Shaft Supporting Bearing Fitting; Driving Pulley Shaft Supporting Bearing Removal

- Refit the seeger ring.
Driving pulley shaft supporting bearing removal
- Remove the transmission cover.
- Remove the seeger ring.
- Take out the bearing using the specific tool.
Specific tooling
001467Y007 Driver for OD 54 mm bearing
001467Y006 Pliers to extract 20 mm bearings
Driving pulley shaft supporting bearing fitting
- Heat the transmission cover interior using the heat gun.
Specific tooling
020151Y Air heater
Engine GP 800 i.e.
ENG - 6