Gilera GP 800 i.e. - Chassis and Suspension Components

MINIMUM OIL PRESSURE SENSOR
Normally closed switch
Activation threshold: 0.3 - 0.6 bar
With the engine off: continuity between terminal
and ground
STATOR
Resistance between terminals: 0.2 ÷ 1 Ohm
Terminal insulation from ground
Frame and suspensions
FRAME AND SUSPENSIONS
Specification Desc./Quantity
Chassis Double cradle with tubular and steel stamped
plates
Front suspension Hydraulic telescopic fork, single plate, ø 41-mm
straight stems.
Front suspension travel 126 mm
Oil quantity for stem 295 ± 3 cm³
Unloaded spring length ----- mm
Rear suspension Single shock absorber that acts directly on the
fork.
Rear suspension travel 135 mm
Brakes
BRAKES
Specification Desc./Quantity
Front brake Ø 300-mm double disc brake with hydraulic control
activated by the handlebar right-hand lever.
Two floating callipers, ø 28 double plunger
Rear brake Ø 280-mm disc brake, with hydraulic servo oper-
ated from the handlebar with the left-hand lever.
One floating calliper with a single plunger
Characteristics GP 800 i.e.
CHAR - 12