A certain lowering of the level is caused by wear
on the pads.
Top-up
- Undo screws «B» and remove the reservoir cap
«A». Top-up using only the fluid specified, without
exceeding the maximum level.
This procedure applies to the rear brake pump top-
up operation; follow the same procedure for the
front brake pump.
Under standard climatic conditions, replace cool-
ant as indicated in the scheduled maintenance
table.
Recommended products
AGIP BRAKE 4 Brake fluid
FMVSS DOT 4 Synthetic fluid
Headlight adjustment
Proceed as follows:
- Place the vehicle in running order and with the
tyres inflated to the prescribed pressure, on a flat
surface 10 m away from a white screen situated in
a shaded area, making sure that the longitudinal
axis of the vehicle is perpendicular to the screen;
- Turn on the headlight and check that the limit of
the light beam projected on the screen is not high-
er than 9/10 or lower than 7/10 of the height of the
centre of the headlight from the ground.
GP 800 i.e. Maintenance
MAIN - 15
To Next Page
Loading...
