Gilera GP 800 i.e. - Refitting

- Remove the two screws fixing the pump to the
handlebar.
Refitting
- To refit, carry out the removal operations but in reverse order.
CAUTION
ONCE REFITTING IS FINISHED, BLEED THE SYSTEM.
Locking torques (N*m)
Screws fixing brake pump to handlebar 7 ÷ 10 Brake pipes / brake pump coupling 16 ÷ 20
Removal
- Remove the two contacts from the stop light
switch.
- Drain off the braking system corresponding to the
circuit being tested.
- Remove the oil pipe coupling.
GP 800 i.e. Braking system
BRAK SYS - 13