Gilera GP 800 i.e. - Checking the Spark Advance; Spark Plug

Km x 1000 1 5 1
0
1
5
2
0
2
5
3
0
3
5
4
0
4
5
5
0
5
5
6
0
6
5
7
0
7
5
8
0
8
5
9
0
9
5
10
0
Suspensions ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Centre stand ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Vehicle road test ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Checking the spark advance
See also
Refitting the timing chain
Spark plug
To replace the rear cylinder spark plugs:
- Tip the saddle forwards, undo the five screws
«A» and remove cover «B».
- Disconnect caps «C» of the HV wire of the spark
plugs.
- Unscrew the spark plugs using the wrench sup-
plied.
- Upon refitting, place the spark plugs into the hole at the due inclination and tighten them by hand.
- Only use the wrench to lock spark plugs in place.
- Place caps «C» fully over the spark plugs.
- Refit cover «B».
CAUTION
SPARK PLUGS MUST BE REMOVED WHEN THE ENGINE IS COLD. SPARK PLUGS MAINTE-
NANCE OPERATIONS ARE DESCRIBED IN THE SCHEDULED MAINTENANCE TABLE. USING
NON-CONFORMING ELECTRONIC CENTRAL UNITS AND ELECTRONIC IGNITIONS OR SPARK
PLUGS OTHER THAN THOSE PRESCRIBED MAY SERIOUSLY DAMAGE THE ENGINE.
N.B.
THE USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR OF SHIELDLESS SPARK
PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAILURES.
GP 800 i.e. Maintenance
MAIN - 3