Gilera GP 800 i.e. - Page 312

- Remove the internal spacer.
- Repeat the previously described procedure to
pull out the other bearing from the opposite side.
- Visually inspect that the internal spacer and the
bearing seats exhibit no signs of abnormal wear.
- Heat the seat of one bearing with the specific tool.
Specific tooling
020151Y Air heater
- Insert a new bearing until it stops with the specific
tool.
Specific tooling
020376Y Adaptor handle
020483Y 30 mm guide
020655Y Adaptor 62x68 mm
- Fit the internal spacer from the opposite side.
- Repeat the previously described procedure to fit
the other bearing.
Suspensions GP 800 i.e.
SUSP - 26