Gilera GP 800 i.e. - Page 302

- Grease and fit a new dust guard.
- Fit the fork leg together with the stem on the fork
support clamp until it stops.
- Tighten the three screws to the prescribed torque
in the sequence indicated in the photograph.
Locking torques (N*m)
Stem support clamp tightening screws 20 ÷ 25
- Refill the fork leg with the recommended product
to the prescribed amount.
Recommended products
AGIP FORK 7.5 W Oil for front fork
Hydraulic fluid SAE 7.5 W
Characteristic
Oil quantity for stem
295 ± 3 cm³
- Bleed the hydraulic rod by actuating the stem re-
peatedly.
- Fit the spring into the stem.
Suspensions GP 800 i.e.
SUSP - 16