To Next Page

To Previous Page

P a g e | 103

UCM630X Series User Manual

Version 1.0.2.25

Model configuration

Model templates

Model layer configuration allows users to apply model-specific configurations to different devices. Users could

create/edit/delete a model template by accessing Web GUI, page Value-added FeaturesZero

ConfigModel Templates. If multiple model templates are created and enabled, when the user configures the

device in Edit Device dialogAdvanced Settings, the user can select to use one of the model templates for the

device. Please refer to section [Manage Devices] for more details on using the model template.

For each created model template, users can assign it as default model template. If assigned as default model

template, the values in this model template will be applied to all the devices of this model. There is always only

one default model template that can be assigned at one time on the UCM630X.

The selected model template and the default model template will both take effect when generating the config file

for the device. However, the model template has higher priority to default model template when it comes to the

same setting option/field. If the same option/field has different value configured in the default model template

and the selected model template, the value for this option/field in the selected model template will override the

value in default model template.

 Click on “Add” to add a model template.

Table 32: Create New Model Template

Model

Select a model to apply this template. The supported Grandstream models

are listed in the dropdown list for selection.

Template Name

Create a name for the model template.

Description

Enter a description for the model template. This is optional.

Default Model Template

Select to assign this model template as the default model template. The value

of the option in default model template will be overridden if other selected

model template has a different value for the same option.

Active

Check this option to enable the model template.

 Click on to edit the model template.

The editing window for model template is shown in the following figure. In the “Options” field, enter the option

name key word, the option that contains the key word will be listed. User could then select the option to be

modified under the model template.

Grandstream Networks UCM63 Series User Manual

Other manuals for Grandstream Networks UCM63 Series