P a g e | 203
UCM630X Series User Manual
Version 1.0.2.25
Figure 118: Inbound Route - Route-Level Mode
Global inbound mode must be enabled before configuring Route-Level Inbound Mode. Additionally, the Mode 1
must be configured as well.
When Route-Level Inbound Mode is enabled, the user can configure a “Default Destination” and a “Mode 1”
destination for each specific route. By default, the call coming into this specific inbound route will be routed to
the default destination.
Users can toggle the route’s inbound mode by dialing "Global Inbound Mode feature code + Inbound Mode
Suffix” and the current inbound route can be monitored by subscribing a BLF to the Inbound Mode Suffix.
For example, Inbound Default Mode feature code is set to *61 and the Inbound Mode suffix for route 1 is set to
1010. To switch the mode of route 1 to Default Mode, users can dial *611010.
Note: Toggling the global inbound mode will not affect routes that have Route-level Inbound Mode enabled. If
all routes have the option enabled, toggling the global inbound mode via BLF will trigger a voice prompt indicating
that none of the routes will be affected by the global inbound mode change.
Inbound Route: Inbound Mode BLF Monitoring
Users can assign MPKs and VPKs to monitor and toggle the current global inbound mode of the UCM.
To do this, please refer to the following steps:
1. Access the UCM web GUI and navigate to Extension/TrunkInbound Routes.
2. Click on the button and enable Inbound Multiple Mode.
3. Edit the subscribe number field to the desired BLF value.
To Next Page
Loading...
Need help?
General
