Grandstream Networks UCM63 Series User Manual

P a g e | 196
UCM630X Series User Manual
Version 1.0.2.25
Inbound Routes
Inbound routes can be configured via Web GUIExtension/TrunkInbound Routes.
 Click on to add a new inbound route.
 Click on "Blacklist" to configure blacklist for all inbound routes.
 Click on to edit the inbound route.
 Click on to delete the inbound route.
Inbound Rule Configurations
Table 65: Inbound Rule Configuration Parameters
Trunks
Select the trunk to configure the inbound rule.
Pattern
 All patterns are prefixed with the "_".
 Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.
 The pattern can be composed of two parts, Pattern and CallerID Pattern.
The first part is used to specify the dialed number while the second part
is used to specify the caller ID and it is optional, if set it means only the
extension with the specific caller ID can call in or call out. For example,
pattern '_2XXX/1234' means the only extension with the caller ID '1234'
can use this rule.
Note:
 Multiple patterns can be used. Each pattern should be entered in new
line.
 Users can add comments to the end of patterns to better organize and
keep track of complex rules by typing “/*” and “*/” before and after
each comment respectively
Example:
Pattern
CallerID Pattern
_X.
1000
_ NNXXNXXXXX /* 10-digit long distance */
1001

Grandstream Networks UCM63 Series Specifications

General

Brand	Grandstream Networks
Model	UCM63 Series
Category	PBX
Language	English