To Next Page

To Previous Page

P a g e | 169

UCM630X Series User Manual

Version 1.0.2.25

 If there is only one FXO port connected to PSTN line, use the following settings for auto-detection.

Figure 95: UCM630X PSTN Detection: Semi-Auto Detect

Detect Model: Semi-auto Detect.

Source Channel: The source channel to be detected.

Destination Number: The number to be dialed for detecting. This number could be a cell phone number

or other PSTN number that can be reached from the source channel PSTN number.

5. Click "Detect" to start detecting. The source channel will initiate a call to the destination number. For "Auto

Detect", the call will be automatically answered. For "Semi-auto Detect", the UCM630X Web GUI will display

prompt to notify the user to answer or hang up the call to finish the detecting process.

6. Once done, the detected result will show. Users could save the detecting result as the current UCM630X

settings.

Table 54: PSTN Detection for Analog Trunk

Detect Model

Select "Auto Detect" or "Semi-auto Detect" for PSTN detection.

 Auto Detect

Please make sure two or more channels are connected to the

UCM630X and in idle status before starting the detection. During the

detection, one channel will be used as caller (Source Channel) and

another channel will be used as callee (Destination Channel). The

UCM630X will control the call to be established and hang up between

caller and callee to finish the detection.

 Semi-auto Detect

Semi-auto detection requires answering or hanging up the call

Grandstream Networks UCM63 Series User Manual

Other manuals for Grandstream Networks UCM63 Series