Grandstream Networks UCM63 Series User Manual

P a g e | 181
UCM630X Series User Manual
Version 1.0.2.25
Table 60: IAX Peer Trunk Configuration Parameters
Basic Settings
Provider Name
Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules etc.
Host Name
Configure the IP address or URL for the VoIP provider’s server of the trunk.
Keep Trunk CID
If enabled, the trunk CID will not be overridden by extension's CID when the
extension has CID configured. The default setting is "No".
Disable This Trunk
If selected, the trunk will be disabled.
Caller ID
Configure the Caller ID. This is the number that the trunk will try to use when
making outbound calls. For some providers, it might not be possible to set the
CallerID with this option and this option will be ignored.
Important Note: When making outgoing calls, the following priority order rule will
be used to determine which CallerID will be set before sending out the call :
CID from inbound call (Keep Original CID Enabled)  Trunk Username/CallerID
(Keep Trunk CID Enabled)  DOD  Extension CallerID Number  Trunk
Username/CallerID (Keep Trunk CID Disabled)  Global Outbound CID..
CallerID Name
Configure the name of the caller to be displayed when the extension has no
CallerID Name configured.
Advanced Settings
Codec Preference
Select audio and video codec for the VoIP trunk. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, iLBC, ADPCM,
H.264, H.265, H.263, H.263p and VP8.
Enable Heartbeat
Detection
If enabled, the UCM630X will regularly send SIP OPTIONS to the device to check
if the device is still online. The default setting is "No".
Heartbeat Frequency
When "Enable Heartbeat Detection" option is set to "Yes", configure the interval
(in seconds) of the SIP OPTIONS message sent to the device to check if the device
is still online. The default setting is 60 seconds.
Maximum Number of
Call Lines
The maximum number of concurrent calls using the trunk. The default settings 0,
which means no limited.
FECC
Configure to enable Far-end Camera Control
Trunk Groups
Users can create VoIP Trunk Groups to register and easily apply the same settings on multiple accounts within
the same SIP server. This can drastically reduce the amount of time needed to manage accounts for the same
server and improve the overall cleanliness of the web UI.

Grandstream Networks UCM63 Series Specifications

General

Brand	Grandstream Networks
Model	UCM63 Series
Category	PBX
Language	English