Grandstream Networks UCM63 Series User Manual

P a g e | 329
UCM630X Series User Manual
Version 1.0.2.25
Auto Kill
If enabled and no ACK is received for new messages after the specified wait time,
the connection will be terminated.
Authentication
Debugging
If enabled, authentication traffic in debugging will not show. The default is "No".
Codec Priority
Configure codec negotiation priority. The default setting is "Reqonly".
 Caller
Consider the callers preferred order ahead of the host's.
 Host
Consider the host's preferred order ahead of the caller's.
 Disabled
Disable the consideration of codec preference all together.
 Reqonly
This is the same as "Disabled", except when the requested format is not
available. The call will only be accepted if the requested format is available.
Type of Service
Configure ToS bit for preferred IP routing.
IAX Trunk Options
Trunk Frequency
Configure the frequency of trunk frames (in milliseconds). The default is 20.
Trunk Time Stamps
If enabled, time stamps will be attached to trunk frames. The default is "No".
IAX Settings/Security
Table 113: IAX Settings/Static Defense
Call Token Optional
Enter a single IP address (e.g., 11.11.11.11) or a range of IP addresses
(11.11.11.11/22.22.22.22) for which call token validation is not required.
Max Call Numbers
Configure the maximum number of calls allowed for a single IP address.
Max Unvalidated Call
Numbers
Configure the maximum number of Unvalidated calls for all IP addresses.
Max Call Numbers
Configure to limit the number of calls for a give IP address of IP range.
IP or IP Range
Enter the IP address (11.11.11.11) or a range of IP addresses
(11.11.11.11/22.22.22.22) to be considered for call number limits.

Grandstream Networks UCM63 Series Specifications

General

Brand	Grandstream Networks
Model	UCM63 Series
Category	PBX
Language	English