To Next Page

To Previous Page

P a g e | 170

UCM630X Series User Manual

Version 1.0.2.25

manually. Please make sure one channel is connected to the

UCM630X and in idle status before starting the detection. During the

detection, source channel will be used as caller and send the call to

the configured Destination Number. Users will then need follow the

prompts in Web GUI to help finish the detection.

The default setting is "Auto Detect".

Source Channel

Select the channel to be detected.

Destination Channel

Select the channel to help detect when "Auto Detect" is used.

Destination Number

Configure the number to be called to help the detection.

---------------------------------------------------------------------------------------------------------------------------------------------------

Note:

 The PSTN detection process will keep the call up for about 1 minute.

 If "Semi-auto Detect' is used, please pick up the call only after informed from the Web GUI prompt.

 Once the detection is successful, the detected parameters "Busy Tone", "Polarity Reversal" and "Current

Disconnect by PSTN" will be filled into the corresponding fields in the analog trunk configuration.

---------------------------------------------------------------------------------------------------------------------------------------------------

Grandstream Networks UCM63 Series User Manual

Other manuals for Grandstream Networks UCM63 Series