P a g e | 128
UCM630X Series User Manual
Version 1.0.2.25
The time condition of DND. The DND will take effect while the time condition is
satisfied.
If DND is enabled, calls from the whitelisted numbers will not be rejected. Multiple
numbers are supported and must be separated by new lines. Pattern matching is
supported.
Z match any digit from 1-9,
N match any digit from 2-9,
X match any digit from 0-9.
Calls from users in the forward whitelist will not be forwarded.
Pattern matching is supported.
Z match any digit from 1-9,
N match any digit from 2-9,
X match any digit from 0-9.
Enable this option to have an external number ring simultaneously along with the
extension. If a register trunk is used for outbound, the register number will be used to
be displayed for the external number as caller ID number.
Set the external number to be rang simultaneously. ‘-’ is the connection character
which will be ignored.
Time Condition for
Ring
Simultaneously
Ring the external number simultaneously along with the extension on the basis of this
time condition.
Use callee DOD on
FWD or RS
Use the callee's DOD number as CallerID on Outgoing Forwarding or Ring
Simultaneously calls.
Monitor privilege control
Members of the list can spy on this extension via feature codes.
Seamless transfer privilege control
Allowed to
seamless transfer
Members of the list can seamlessly transfer via feature code.
Configure the number of seconds to ring the user before the call is forwarded to
voicemail (voicemail is enabled) or hang up (voicemail is disabled). If not specified,
the default ring timeout is 60 seconds on the UCM630X, which can be configured in
the global ring timeout setting under Web GUIPBX SettingsVoice
PromptCustom Prompt: General Preference. The valid range is between 5 seconds
and 600 seconds.
Note: If the end point also has a ring timeout configured, the actual ring timeout used
is the shortest time set by either device.