P a g e | 146
UCM630X Series User Manual
Version 1.0.2.25
If DND is enabled, calls from the whitelisted numbers will not be rejected. Multiple
numbers are supported and must be separated by new lines. Pattern matching is
supported.
Z match any digit from 1-9，
N match any digit from 2-9，
X match any digit from 0-9.
Calls from users in the forward whitelist will not be forwarded. Pattern matching is
supported.
Z match any digit from 1-9，
N match any digit from 2-9，
X match any digit from 0-9.
Enable this option to have an external number ring simultaneously along with the
extension. If a register trunk is used for outbound, the register number will be used to
be displayed for the external number as caller ID number.
Set the external number to be rang simultaneously. ‘-’ is the connection character
which will be ignored.
This field accepts only letters, numbers, and special characters + = * #.
Time Condition for
Ring
Simultaneously
Ring the external number simultaneously along with the extension on the basis of this
time condition.
Use callee DOD on
FWD or RS
Use the DOD number when calls are being diverted/forwarded to external
destinations or when ring simultaneous is configured.
Monitor privilege control
Add members from “Available Extensions” to “Selected Extensions” so that the
selected extensions can spy on the used extension using feature code.
Seamless transfer privilege control
Allowed to
seamless transfer
Any extensions on the UCM can perform seamless transfer. When using Pickup Incall
feature, only extensions available on the “Selected Extensions” list can perform
seamless transfer to the edited extension.
Configure the number of seconds to ring the user before the call is forwarded to
voicemail (voicemail is enabled) or hang up (voicemail is disabled). If not specified,
the default ring timeout is 60 seconds on the UCM630X, which can be configured in
To Next Page
Loading...
Need help?
General
