P a g e | 290
UCM630X Series User Manual
Version 1.0.2.25
---------------------------------------------------------------------------------------------------------------------------------------------------
Notes:
To configure LDAP sync, please go to UCM630X Web GUIExtension/TrunkVoIP Trunk. You will see
"Sync LDAP Enable" option. Once enabled, please configure password information for the remote peer
UCM630X to connect to the local UCM630X. Additional information such as port number, LDAP outbound
rule, LDAP Dialed Prefix will also be required. Both the local UCM630X and remote UCM630X need enable
LDAP sync option with the same password for successful connection and synchronization.
Currently LDAP sync feature only works between two UCM630Xs.
(Theoretically) Remote BLF monitoring will work when the remote PBX being monitored is non-UCM630X
PBX. However, it might not work the other way around depending on whether the non-UCM630X PBX
supports event list BLF or remote monitoring feature.
---------------------------------------------------------------------------------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General
