P a g e | 301
UCM630X Series User Manual
Version 1.0.2.25
Default Code: *45 (Disabled by default).
If “Pickup In-call” feature is enabled, only the extensions added
in “Allowed to seamless transfer” in the extension’s Seamless
Transfer Privilege Control List” can pick up the call.
Default Code: *8
This code is for the pickup group, which can be assigned for
each extension on the extension configuration page.
If there is an incoming call to an extension, the other extensions
within the same pickup group can dial *8 directly to pick up the
call.
Direct Dial Voicemail Prefix
Default Code: *
This code is for the user to directly dial or transfer to an
extension's voicemail.
For example, directly dial *5000 will have to call go into the
extension 5000's voicemail. If the user would like to transfer the
call to the extension 5000's voicemail, enter *5000 as the
transfer target number.
Direct Dial Mobile Phone Prefix
Default Code: *88
If you have the permission to call mobile phone number, use
this prefix plus the extension number can dial the mobile phone
number of this extension directly.
Default Code: *11
This code is for the user who wants to use Call Completion to
complete a call.
Default Code: *12
This code is for the user who wants to cancel Call Completion
request.
Check this box to enable spy feature codes. Disabled by default.
Default Code: *54 (“Enable Spy” needs to be checked)
This is the feature code to listen in on a call to monitor
performance. Monitor’s line will be muted, and neither party will
hear from the monitor’s extension.
Default Code: *55 (“Enable Spy” needs to be checked)
This is the feature code to speak to one side of the call (for
example, whisper to employees to help them handle a call).
Only one side will be able to hear from the monitor’s extension.
To Next Page
Loading...
Need help?
General
