GDM-906X Series User Manual
146
Frequency
Compensate
(1.000017)
Enable or disable frequency compensation
(the value indicates the compensation
coefficient; default: Factory calibration value)
Check the box to enable:
Frequency = Original Frequency x
Compensate Coefficient
Uncheck the box to disable:
Frequency = Original Frequency
Select either Auto or Manual frequency cali
method. When Manual is opted, input a
frequency compensation coefficient directly.
1. Select Manual mode.
2. Input a compensation coefficient.
3. Use the Left/Right keys to move the
cursor followed by pressing the F5
(Enter) key to save the frequency
compensation coefficient. The value
changes as the figure shown below.
To Next Page
Loading...
Need help?
General
