GDM-906X Series User Manual
194
The time parameters of the selected
lowest, highest and delta values
display in the clear time format
below, which indicate the exact day
and time when the selected values
occurred respectively.
F5 & F6
keys
(1ST ON
& 2ND
ON)
The Stop&View under Trend Chart is also
applicable to the dual measurement. Activating
dual measurement followed by entering this
mode where the statistics are almost identical to
those of the previous single measurement.
User can view each data for dual measurements
or toggle on/off for either 1ST or 2ND channel
at any time per requirement.
F6 (Start) key
to restart
measurement
After entering the View Setup (Trend) mode, system will halt
the measurement right away. Exit the View Setup (Trend)
mode and press the F6 (Start) key to restart measurement.
When measurement is ongoing, press the F6 (ReStart) key to
recount the accumulated measurements.
To Next Page
Loading...
Need help?
General
