GW Instek GDM-906 Series - Page 283

REMOTE CONTROL
283
[SENSe:]DIODe:TRIGger:DELay
Sets the trigger delay that minimum step is microseconds of Diode
measurement.
Parameter: <NRf>(0 ~ 3600 s) | MIN | MAX | DEF
Example: SENS:DIOD:TRIG:DEL 0.5
Sets the trigger delay time to 500ms of Diode measurement.
[SENSe:]DIODe:TRIGger:DELay?
Returns the trigger delay time in seconds of Diode measurement.
Return parameter: <NRf>
[SENSe:]DIODe:ZERO:AUTO
Sets the auto zero mode to on, off or once only of Diode measurement.
Parameter: 0 | 1 | ON | OFF | ONCE
Example: SENS:DIOD:ZERO:AUTO ON
Sets the auto zero to on.
[SENSe:]DIODe:ZERO:AUTO?
Returns the auto zero mode of Diode measurement.
Return Parameter: 0 | 1, 1=ON, 0=OFF
SENSe VOLTage Commands
[SENSe:]VOLTage[:DC]:IMPedance:AUTO
Sets the Automatic input impedance for DC Voltage measurement.
Parameter: 0 | 1 | ON | OFF
Example: SENS:VOLT:DC:IMP:AUTO ON
Turns the Automatic input impedance on.
[SENSe:]VOLTage[:DC]:IMPedance:AUTO?
Returns the Automatic input impedance mode.
Return parameter: 0 | 1, 0=OFF, 1=ON
[SENSe:]VOLTage[:DC]:NPLCycles
Sets the integration time for DC Voltage measurement in PLCs (power line
cycles). Where one PLC is equal to 16.6 milliseconds. For any <NRf>
parameter, the DMM will automatically set the PLC to the closest
acceptable PLC value (0.006 | 0.0083 | 0.0125 | 0.025 | 0.05 | 0.15 | 0.6 | 1 | 3
| 12).
Parameter: NPLCycles(<NRf> | MIN | MAX | DEF)
Example: SENS:VOLT:DC:NPLC 12
Sets the integration time to 12 PLCs for DC Voltage measurements.
[SENSe:]VOLTage[:DC]:NPLCycles?
Returns the integration time for DC Voltage measurement in PLCs (power
line cycles). Where one PLC is equal to 16.6 milliseconds.
Return parameter: 0.006 | 0.0083 | 0.0125 | 0.025 | 0.05 | 0.15 | 0.6 | 1 | 3 | 12