GW Instek GDM-906 Series - Page 287

REMOTE CONTROL
287
[SENSe:]VOLTage:AC:TRIGger:DELay
Sets the trigger delay time that minimum step is microseconds of AC
Voltage measurement.
Parameter: <NRf>(0 ~ 3600 s) | MIN | MAX | DEF
Example: SENS:VOLT:AC:TRIG:DEL 0.4
Sets the trigger delay time to 400ms of AC Voltage measurement.
[SENSe:]VOLTage:AC:TRIGger:DELay?
Returns the trigger delay time in seconds of AC Voltage measurement.
Return parameter: <NRf>
SENSe CURRent Commands
[SENSe:]CURRent[:DC]:NPLCycles
Sets the integration time for DC Current measurement in PLCs (power line
cycles). Where one PLC is equal to 16.6 milliseconds. For any <NRf>
parameter, the DMM will automatically set the PLC to the closest
acceptable PLC value (0.006 | 0.0083 | 0.0125 | 0.025 | 0.05 | 0.15 | 0.6 | 1 | 3
| 12).
Parameter: NPLCycles(<NRf> | MIN | MAX | DEF)
Example: SENS:CURR:DC:NPLC 1
Sets the integration time to 1 PLCs for DC Current measurement.
[SENSe:]CURRent[:DC]:NPLCycles?
Returns the integration time for DC Current measurement in PLCs (power
line cycles). Where one PLC is equal to 16.6 milliseconds.
Return parameter: 0.006 | 0.0083 | 0.0125 | 0.025 | 0.05 | 0.15 | 0.6 | 1 | 3 | 12
[SENSe:]CURRent[:DC]:NULL[:STATe]
Sets the relative function on/off for DC Current measurement.
Parameter: 0 | 1 | ON | OFF
Example: SENS:CURR:DC:NULL:STAT ON
Turns the relative function on for DC Current measurement.
[SENSe:]CURRent[:DC]:NULL[:STATe]?
Returns the relative function state of DC Current measurement.
Return parameter: 0 | 1, 0=OFF, 1=ON
[SENSe:]CURRent[:DC]:NULL:VALue
Sets the relative value for DC Current measurement.
Parameter: <NRf> (-12.0~12.0 A) | MIN | MAX | DEF
Example: SENS:CURR:DC:NULL:VAL 1.1
Sets the relative value to 1.1A for DC Current measurement.
[SENSe:]CURRent[:DC]:NULL:VALue?
Returns the current relative value of DC Current measurement.