Press the F5 key to enter timeout menu. Click
the F1 – F2 key for the desired timeout setting.
See the figure below with available options.
Note: When selecting “Auto”, the timeout
setting will fully sync with the gate time value.
Press the “+” or the “-” key to promptly
select the range. The Auto indicator
turns to indicating Manual range
selection. If the appropriate range is
unknown, select the highest range.
You can also press the F1 (AC Range) key to
select a range for the measurement.
Depending on the InJack setting, the
available options vary. See examples below.
When InJack is Voltage:
Press the F1 ~ F6 key to select a desired
range for the measurement.
When InJack is 3A:
Press the F1 ~ F5 key to select a desired
range for the measurement.
Press the F6 (More 1/2) key for next page
with more options as figure shown below.
When InJack is 10A (GDM-9061 only):
Press the F1 ~ F2 key to select a desired
parameter for the measurement.
To Next Page
Loading...
