GW Instek GDS-1000B Series - Measurement Commands; Measurement:meas<X>:Source<X

GDS-1000B Programming Manual
106
Measurement Commands
:MEASUrement:MEAS<X>:SOURCE<X> .................. 106
:MEASUrement:MEAS<X>:TYPe ............................... 107
:MEASUrement:MEAS<X>:STATE ............................ 107
:MEASUrement:MEAS<X>:VALue ............................ 108
:MEASUrement:MEAS<X>:MAXimum ..................... 109
:MEASUrement:MEAS<X>:MEAN ............................ 110
:MEASUrement:MEAS<X>:MINImum ..................... 110
:MEASUrement:MEAS<X>:STDdev .......................... 111
:MEASUrement:STATIstics:MODe ........................... 112
:MEASUrement:STATIstics:WEIghting ..................... 112
:MEASUrement:STATIstics ....................................... 113
:MEASUrement:MEAS<X>:SOURCE<X>
Description
Sets or queries the measurement source for a
selected automatic measurement. This is a statistics
related command.
Syntax
:MEASUrement:MEAS<X>:SOURCE<X> { CH1 | CH2 |
CH3 | CH4 | MATH | ? }
Related
commands
:MEASUrement:MEAS<X>:TYPe
Parameter
MEAS<X>
The automatic measurement number
from 1 to 8.
SOURCE<X>
SOURCE1: the source for all single
channel measurements.
SOURCE<X>
SOURCE2: the source for all delay or
phase measurements.
CH1 to CH4
Channel 1, 2, 3, 4
MATH
Math source
Set
Query