GW Instek GDS-1000B Series - Trigger:bus:b1:Uart:rx:data:value; Trigger:bus:b1:Uart:tx:data:size

COMMAND DETAILS
147
:TRIGger:BUS:B1:UART:RX:DATa:VALue
Description
Sets or queries the triggering data value for the
UART bus when the bus is set to trigger on Rx
Data.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:UART:RX:DATa:VALue {<string> | ? }
Related
commands
:TRIGger:BUS:B1:UART:RX:DATa:SIZe
Parameter
<sting>
The number of characters in the string
depends on the data size setting. The
string must be enclosed in double
quotes, "string".
x = don’t care
1 = binary 1
0 = binary 0
Return Parameter
Returns the data value.
Example1
:TRIGger:BUS:B1:UART:CONDition RXDATA
:TRIGger:BUS:B1:UART:RX:DATa:SIZe 1
:TRIGger:BUS:B1:UART:RX:DATa:VALue "1x1x0101"
Sets the value to 1x1x0101
Example 2
:TRIGger:BUS:B1:UART:RX:DATa:VALue?
1X1X0101
:TRIGger:BUS:B1:UART:TX:DATa:SIZe
Description
Sets or queries the number of bytes for UART data.
Note
This setting only applies when the UART trigger is
set to trigger on Tx Data
Set
Query
Set
Query