GW Instek GDS-1000B Series - Save;Recall Commands; Recall:setup; Recall:waveform

GDS-1000B Programming Manual
164
Save/Recall Commands
:RECAll:SETUp ........................................................... 164
:RECAll:WAVEform .................................................... 164
:SAVe:IMAGe ............................................................. 165
:SAVe:IMAGe:FILEFormat ......................................... 165
:SAVe:IMAGe:INKSaver ............................................. 166
:SAVe:SETUp ............................................................. 166
:SAVe:WAVEform ....................................................... 167
:SAVe:WAVEform:FILEFormat .................................. 168
:RECAll:SETUp
Description
Recalls setup settings from memory or USB.
Syntax
:RECAll:SETUp {S1~S20 | <file
path>("Disk:/xxx.SET","USB:/xxx.SET")}
Parameter
S1~S20
Recall Set1~Set20
<file path>
Recall a file from the DSO internal files
system or from a USB flash drive.
Example
:RECAll:SETUp S1
Recalls setup setting S1 from memory.
:RECAll:SETUp “Disk:/DS0001.SET”
Recall the setup setting DS0001.SET from the internal
memory.
:RECAll:WAVEform
Description
Recalls a waveform from wave1~wave20 or from
file to REF1~4.
Note
Detail CSV files cannot be recalled.
Syntax
:RECAll:WAVEform {W<n> | <file path>
(“Disk:/xxx.LSF”,”USB:/xxx.LSF”)},REF<X>
Set
Set