GW Instek GDS-1000B Series - Segment Commands; Segments:state

COMMAND DETAILS
227
Segment Commands
:SEGMents:STATE .....................................................227
:SEGMents:CURRent .................................................228
:SEGMents:TOTalnum ..............................................228
:SEGMents:TIMe .......................................................229
:SEGMents:DISPALL .................................................229
:SEGMents:MEASure:MODe ....................................229
:SEGMents:MEASure:PLOT:SOURce .......................230
:SEGMents:MEASure:PLOT:DIVide ..........................230
:SEGMents:MEASure:PLOT:SELect ..........................231
:SEGMents:MEASure:PLOT:RESults .........................231
:SEGMents:MEASure:TABle:SOURce .......................232
:SEGMents:MEASure:TABle:SELect ..........................232
:SEGMents:MEASure:TABle:LIST .............................233
:SEGMents:MEASure:TABle:SAVe ............................233
:SEGMents:SAVe .......................................................233
:SEGMents:SAVe:SOURce ........................................234
:SEGMents:SAVe:SELect:STARt ................................234
:SEGMents:SAVe:SELect:END ..................................235
:SEGMents:STATE
Description
Turns the segmented memory function on/off or
queries its state.
Syntax
:SEGMents:STATE { OFF | ON | ? }
Related
commands
:RUN
:STOP
Parameter/
Return parameter
OFF
Turns the segmented memory off.
ON
Turns the segmented memory on.
Example1
:SEGMents:STATE ON
Turns segmented memory on.
Set
Query