GW Instek GDS-1000B Series - Trigger:external:probe:ratio; Trigger:bus:type

COMMAND DETAILS
139
:TRIGger:EXTERnal:PROBe:RATio
Description
Sets or queries the external probe ratio
(attenuation).
Syntax
:TRIGger:EXTERnal:PROBe:RATio {<NRf> | ?}
Related
commands
:TRIGger:EXTERnal:PROBe:TYPe
Parameter
<NRf>
External probe attenuation factor.
Return parameter
<NR3>
Returns the probe attenuation factor.
Example
:TRIGger:EXTERnal:PROBe:RATio?
5.000000e+01
:TRIGger:BUS:TYPe
Description
Returns the current bus type.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:TYPe?
Return parameter
12C
I
2
C mode
SPI
SPI mode
UART
UART mode
CAN
CAN mode
LIN
LIN mode
Example
:TRIGger:BUS:TYPe?
UART
Set
Query
Query