GW Instek GDS-1000B Series - Trigger:bus:b1:Uart:tx:data:value

GDS-1000B Programming Manual
148
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:UART:TX:DATa:SIZe {<NR1> | ?}
Related
commands
:TRIGger:BUS:B1:UART:CONDition
Parameter
<NR1>
Number of bytes (1 to 10).
Return parameter
<NR1>
Returns the number of bytes.
Example
:TRIGger:BUS:B1:UART:TX:DATa:SIZe 5
Sets the number of bytes to 5.
:TRIGger:BUS:B1:UART:TX:DATa:VALue
Description
Sets or queries the triggering data value for the
UART bus when the bus is set to trigger on Tx
Data.
Syntax
:TRIGger:BUS:B1:UART:TX:DATa:VALue {<string> | ? }
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Related
commands
:TRIGger:BUS:B1:UART:TX:DATa:SIZe
Parameter
<sting>
The number of characters in the string
depends on the data size setting. The
string must be enclosed in double
quotes, "string".
x = don’t care
1 = binary 1
0 = binary 0
Return Parameter
Returns the data value.
Set
Query