GW Instek GDS-1000B Series - Cursor:ddt; Cursor:vuni; Cursor:vuse

GDS-1000B Programming Manual
66
:CURSor:VUNI
Description
Sets or queries the units for the vertical bar cursors.
Syntax
:CURSor:VUNI {BASE | PERcent | ?}
Related
Commands
:CURSor:MODe
Parameter
BASE
Sets the vertical cursor units the same
as the scope units (V or A).
PERcent
Sets the displayed units to percent.
Return parameter
Returns the unit type.
Example
:CURSor:VUNI BASE
Sets the units to the base units.
:CURSor:VUSE
Description
Sets the current cursor position as the ratio
reference for the Percent (vertical) cursors.
Note
This command can only be used when
:CURSor:VUNI is set to PERcent.
Syntax
:CURSor:VUSE {CURRent}
Related
Commands
:CURSor:MODe
:CURSor:VUNI
Parameter
CURRent
Uses the current vertical position
Example
:CURSor:VUSE CURRent.
:CURSor:DDT
Description
Returns the deltaY/deltaT (dy/dT) readout. This
function is only supported if the source channels
are CH1~4, Ref1~4 or Math.
Syntax
:CURSor:DDT{?}
Set
Query
Set
Query