GW Instek GDS-1000B Series - Trigger:bus:b1:Spi:condition; Trigger:bus:b1:Spi:data:size

COMMAND DETAILS
149
Example1
:TRIGger:BUS:B1:UART:CONDition TXDATA
:TRIGger:BUS:B1:UART:TX:DATa:SIZe 1
:TRIGger:BUS:B1:UART:TX:DATa:VALue "1x1x0101"
Sets the value to 1x1x0101
Example 2
:TRIGger:BUS:B1:UART:TX:DATa:VALue?
1X1X0101
:TRIGger:BUS:B1:SPI:CONDition
Description
Sets or queries the SPI triggering condition.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:SPI:CONDition {SS | MISO | MOSI |
MISOMOSI | ? }
Parameter
SS
Set to trigger on the Slave Selection
condition.
MISO
Set to trigger on the Master-In
Slave-Out condition.
MOSI
Set to trigger on the Master-Out
Slave-In condition.
MISOMOSI
Set to trigger on the Master-In
Slave-Out and Master-Out Slave-In
conditions.
Return Parameter
Returns the triggering condition.
Example
:TRIGger:BUS:B1:SPI:CONDition MISO
Sets the SPI bus to trigger on MISO.
:TRIGger:BUS:B1:SPI:DATa:SIZe
Description
Sets or queries the number of words for SPI data.
Set
Query
Set
Query