GW Instek GDS-1000B Series - Go_Nogo Commands; Gonogo:clear; Gonogo:execute

GDS-1000B Programming Manual
238
Go_NoGo Commands
The GoNoGo APP must first be launched (or use the command,
“:GONogo:SCRipt”) before any of the Go_NoGo or Template
commands can be used.
:GONogo:CLEar ......................................................... 238
:GONogo:EXECute .................................................... 238
:GONogo:FUNCtion .................................................. 239
:GONogo:NGCount .................................................. 239
:GONogo:NGDefine .................................................. 239
:GONogo:SOURce .................................................... 240
:GONogo:VIOLation ................................................. 240
:GONogo:SCRipt ....................................................... 240
:TEMPlate:MODe ...................................................... 241
:TEMPlate:MAXimum ................................................ 241
:TEMPlate:MINimum ................................................ 241
:TEMPlate:POSition:MAXimum ................................ 242
:TEMPlate:POSition:MINimum ................................ 242
:TEMPlate:SAVe:MAXimum ...................................... 242
:TEMPlate:SAVe:MINimum ...................................... 243
:TEMPlate:TOLerance ................................................ 243
:TEMPlate:SAVe:AUTo............................................... 243
:GONogo:CLEar
Description
Clears the Go/NoGo counter.
Syntax
:GONogo:CLEar
:GONogo:EXECute
Description
Enables or disables the Go/NoGo function or
queries its state.
Syntax
:GONogo:EXECute {OFF|ON|?}
Set
Set
Query