GW Instek GDS-1000B Series - Trigger:bus:b1:I2 C:address:mode

COMMAND DETAILS
141
ADDRess
Set Address as the I
2
C trigger
condition.
DATA
Set Data as the I
2
C trigger
condition.
ADDRANDDATA
Set Address and Data as the I
2
C
trigger condition.
Return parameter
Returns the I
2
C bus trigger condition.
Example
:TRIGger:BUS:B1:I2C:CONDition ADDRess
Set Address as the I2C trigger condition.
:TRIGger:BUS:B1:I2C:ADDRess:MODe
Description
Sets or queries the I
2
C addressing mode (7 or 10
bits).
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:I2C:ADDRess:MODe {ADDR7 |
ADDR10 | ? }
Related
commands
:TRIGger:BUS:B1:I2C:CONDition
Parameter
ADDR7
7 bit addressing
ADDR10
10 bit addressing
Return Parameter
0
7 bit addressing
1
10 bit addressing
Example
:TRIGger:BUS:B1:I2C:ADDRess:MODe?
0
The addressing mode is currently set to 7 bits.
Set
Query