GW Instek GDS-1000B Series - Trigger:bus:b1:I2 C:address:type; Trigger:bus:b1:I2 C:address:value

GDS-1000B Programming Manual
142
:TRIGger:BUS:B1:I2C:ADDRess:TYPe
Description
Sets the I
2
C bus address type, or queries what the
setting is.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:I2C:ADDRess:TYPe {GENeralcall |
STARtbyte | HSmode | EEPROM | CBUS | ?}
Related
commands
:TRIGger:BUS:B1:I2C:CONDition
Parameter
GENeralcall
Set a general call address (0000 000 0).
STARtbyte
Set a start byte address. (0000 000 1)
HSmode
Set a high-speed mode address.
(0000 1xx x)
EEPROM
Set an EEPROM address.
(1010 xxx x)
CBUS
Set a CBUS address. (0000 001 x)
Return Parameter
Returns the address type
Example
:TRIGger:BUS:B1:I2C:ADDRess:TYPe?
CBUS
:TRIGger:BUS:B1:I2C:ADDRess:VALue
Description
Sets or queries the I
2
C bus address value when the
I
2
C bus is set to trigger on Address or
Address/Data.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:I2C:ADDRess:VALue {<string> | ? }
Set
Query
Set
Query