GW Instek GDS-1000B Series - Trigger:bus:threshold:ch<X; Trigger:bus:b1:I2 C:condition

GDS-1000B Programming Manual
140
:TRIGger:BUS:THReshold:CH<x>
Description
Sets or queries the threshold level for the selected
channel.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:THReshold:CH<X> {<NR3> | ?}
<X>
CH1 ~ CH4
<NR3>
Threshold level
Return Parameter
<NR3>
Returns the threshold level
Example
:TRIGger:BUS:THReshold:CH1 1
Sets the CH1 threshold to 1V.
:TRIGger:BUS:B1:I2C:CONDition
Description
Sets or queries the I
2
C trigger conditions.
Note
This command is only applicable when the Serial
Bus Decode (DS1B-BUS) option is installed. See the
user manual for details.
Syntax
:TRIGger:BUS:B1:I2C:CONDition
{STARt | STOP | REPEATstart | ACKMISS | ADDRess |
DATA | ADDRANDDATA | ? }
Parameter
STARt
Set Start as the I
2
C trigger
condition.
STOP
Set Stop as the I
2
C trigger
condition.
REPEATstart
Set Repeat of Start as the I
2
C
trigger condition.
ACKMISS
Set Missing Acknowledgement
as the I
2
C trigger condition.
Set
Query
Set
Query