2. If you navigated to this display via a specific alarm or alarm state icon (rather than via
the Configure menu), the display is filtered to show only suppression groups that
include the selected point. To see the information for other suppression groups, you can
clear the current filter, by clicking the Clear All Filters button in the top right of the dis-
play.
Tip:
If a custom filter has previously been applied, clicking Clear All Filters
does not reset the summary back to the default view. Rather, all filters are
cleared and the view name is shown with an asterisk indicating it that the
view has been modified.
3. Use the tabs at the bottom of the list of suppression groups to see:
l
Which (if any) alarms in the currently selected suppression group are currently
active (Active Alarms tab).
Responding to alarms
Honeywell 2017 145
To Next Page
Loading...
Need help?
General
