Honeywell FlexLine SmartServo 954 User Manual

COMMISSIONING
192 Service Manual Part No.: 4417340 Revision 1
954 SmartServo FlexLine
Name Value Range Default Value Explanation
[LCD text] 60 Characters - This field is used to
display any
maintenance string on
the display. String
entered in the entity will
appear on the display if
Start presenting Text
command is issued. It
will switch back to
default Level and
Temperature screen if
Stop presenting Text
command is issued
[Start presenting
text]
- - This is command entity
to issue command to
display LCD text on the
Display
[Stop presenting
text]
- - This is command entity
to issue command to
Stop presenting text on
the display and switch
to default display
screen
[Display record] - - Display record entity is
used to display the
data appearing on the
display
[Board W&M
intended]
<enable>
<disable>
<disable> Based on this
configuration, LCD
module checks the
status of W&M read
from servo and update
the LCD with right
symbol.
[Ambient Light
Sensor threshold]
<0…3000> 4 digits 500 Ambient Light Sensor
Threshod value is used
as reference value to
switch on LCD if LCD is
switched off after
configured switch off
time. Switch on LCD is
achieved by covering of
Ambient Light Sensor
with hand or by using
Flash light on the the
Ambient Light sensor. If
appropriate Ambient
Light Sensor threshold
value is not used LCD
may not be switched
on. In that case
configuring LCD switch
off time to zero will
switch on the LCD.

Honeywell FlexLine SmartServo 954 Specifications

General

Brand	Honeywell
Model	FlexLine SmartServo 954
Category	Measuring Instruments
Language	English