MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
16
1. Safety and Information
1.4 Disposal
1.4.1 Touchpoint Pro System
The Touchpoint Pro system is constructed from the following materials:
Wall Mounted Enclosure
Powder coated mild steel
Zintec
19” Rack
Powder coated mild steel
I/O Modules
Casing – Polyamide PA 6.6 V0 (UL94), grey
Contents – printed circuit boards
Power Supply Units
Casing – Back case: Aluminum; Top case (with mesh): Steel with Nickel plating
Contents – printed circuit boards
Ring Coupling Module
Casing – Polyamide PA 6.6 V0 (UL94), green
Contents – printed circuit boards
1.4.2 Packaging
Touchpoint Pro outer packaging is made from cardboard. Facilities for recycling are widely available.
Touchpoint Pro inner packaging (used inside the Wall Mounted Enclosure) is made from Stratocell
®
, a Low
Density Polyethylene (LDPE) foam. The foam can be recycled and used as Stratocell
®
again where such
recycling facilities exist.
To Next Page
Loading...
Need help?
General
