MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
31
3. Mechanical Installation
Fixing bolts should be of minimum diameter 8 mm, to a depth of minimum 50 mm.
Caution: It is the installer’s responsibility to select the appropriate xings taking into account the
structure of the mounting surface and the weight of the enclosure.
The typical weight of the hazardous area enclosure is shown in the table below. Please be aware that the
weight may vary depending on the options selected.
Description Approximate Weight in kg
Hazardous Area Enclosure 42
3.3 Hazardous Area Enclosure
Caution: The Touchpoint Pro enclosure is heavy (refer to table of typical weights, single person lift is
not recommended). Before lifting the enclosure, consider and implement control measures to reduce
the risk of injury. Refer to local safety regulations.
TheTouchpointProrangeincludesawallmountedenclosurewhichiscertiedforuseinhazardousareas/
locations (ATEX/IECEx Zone 2, Class I Div 2, and Class I (Zone 2)). This enclosure can only be used as a
remote unit, no controller option is available.
510
325
560
590
Ø11
780
580
Figure 3.5 Touchpoint Pro Hazardous Area Enclosure
To Next Page
Loading...
Need help?
General
